Pignose 150R Crossmix

Live sound reinforcement, running PA's and general amplifier/amplification questions and discussion.
Post Reply
hemiriffic
newbie
Posts: 7
Joined: July 15th, 2006, 11:35 am
Location: NY

Pignose 150R Crossmix

Post by hemiriffic » July 15th, 2006, 11:48 am

I just picked up an old used Pignose 150R Crossmix amp ....12 inch speaker missing the footswitch of course .... anyways .... its a pretty cool basic little amp ....2 channel reverb blah blah blah .
However I can't seem to find anything out about them .... not on the pignose site , and very little else on the internet
Any info on this amp would be great .... watts? .... ohm rating schematics/manuals etc ....


Thanks in advance for your time

User avatar
97reb
Guitarnoise Denizen
Posts: 1453
Joined: September 20th, 2003, 8:54 pm
Location: Charlotte, North Carolina, USA

Post by 97reb » July 16th, 2006, 7:19 am

Welcome, hemiriffic! Good Luck with that info gathering. I couldn't find anything either. Have fun experimenting.
It is a small world for metal fanatics. I welcome you fellow musicians, especially the metalheads!

hemiriffic
newbie
Posts: 7
Joined: July 15th, 2006, 11:35 am
Location: NY

Post by hemiriffic » July 16th, 2006, 12:22 pm

thanks for the welcome .... not much info at all hehehehe and I think the footswitch will be even harder find !!!
Washburnn WI64D Pignose 150R Amplitube Revalver Guitar Rig Cakewalk Products Beer

User avatar
97reb
Guitarnoise Denizen
Posts: 1453
Joined: September 20th, 2003, 8:54 pm
Location: Charlotte, North Carolina, USA

Post by 97reb » July 17th, 2006, 4:31 am

You don't have to have a pignose pedal to replace the one that's missing. I use a Crate pedal with my Marshall amp and a Peavey pedal with my Vox amp. You just need to figure out what a pedal would do for the amp and find one that does it.
It is a small world for metal fanatics. I welcome you fellow musicians, especially the metalheads!

Wagney
newbie
Posts: 1
Joined: December 11th, 2014, 7:01 pm

Re: Pignose 150R Crossmix

Post by Wagney » December 11th, 2014, 7:09 pm

The problem is the way it's wired you can't just plug another footswitch in...one button controls reverb on / off. The other turns on Crossmix and there are 2 led light to indicate channel...

Post Reply