3 way switch wiring help

Need to know how to setup your guitar? How do you lower your action? How do you get rid of the Milli Vanilli stickers? Look here first.
Post Reply
andomando
newbie
Posts: 1
Joined: March 9th, 2016, 4:28 am

3 way switch wiring help

Post by andomando » April 4th, 2017, 6:46 am

I have a Squier strat,that i have put two humbuckers into, My problem is i have a cheep nasty chinese 3 way lever switch that has 7 connections on it, they normally are 8.
I have 2 volume and 1 tone control. hot wire from neck pickup goes to volume pot one no(3 lug)
hot wire from bridge pickup goes to volume pot two no(3 lug )
These two wires i have connected to the fist two pin,s either end of the switch
I have a wire from the middle pin of the switch going to the tone pot no(1 lug) with capacitor on tone no(2 lug)
to the body of tone pot. A wire from tone no(2 lug) to output jack ,
Volume work fine but no tone working. ----------------
/ 7 6 5 4 3 2 1 /
0 0 0 0 0 SWITCH showing my connection points

regards for any help,,,have not worked out yet how to post url,s

LessPaul
Junior Member
Posts: 69
Joined: January 14th, 2017, 7:23 am
Contact:

Re: 3 way switch wiring help

Post by LessPaul » May 5th, 2017, 7:16 pm

stewmac.com was always my go to when I used to do that kind of thing. I'd call it a 3 position switch tho.

PS if I were in your shoes, i'd probably take a shot at it & then just buy the 8 pin version.

Hope this helps!

PS COMPLETELY guessing here, but if 1 prong is conventionally ground I would guess that's the missing pin & you have to ground to a metal part of the switch.

JamesBLafrance
newbie
Posts: 2
Joined: August 28th, 2017, 9:32 pm

Re: 3 way switch wiring help

Post by JamesBLafrance » August 28th, 2017, 9:45 pm

Its very helpful!

Post Reply