headphone and/or speaker channels cut out randomly and often.
It's not a cable issue, the problem lies with the pots on the unit. They're spongy* and I have to constantly give them a gentle side to side waggle to reestablish contact and correct the problem. The knobs themselves are tight on the posts but the whole knob/post assemblies don't seem to be seated stably in the housing anymore.
I don't have the first clue about repairing electronics.. I'm hoping someone may be able to offer some advice.
Thanks in advance!
* I've had it for years and knocked it onto the floor umpteen times, but it still basically works great and serves my requirements. I'm hoping to keep it going.
Here's a pic:
Unlike in a guitar, and more like in an amp or effect, those pots would be soldered directly to the board, and the signal going through them comes off that board, back into it, and so on. So, I would think that it is loose solders on the board.
I'll try to show a pic with similar soldering and construction. A MOOG Opus 1. Pot on upper left like yours, and trim pots.
In older units, the skirted knobs might help prevent the force, or loosening on the inside if dropped. Check your solders.
like a drunk in a midnight choir
I have tried in my way to be free.
when my interface began to cut out, and my warranty had elapsed, I looked for the company on line.
Lexicon wasn't hard to find. I navigated the web site and found the repair people.
they had a set money amount and they would fix it.
I think I sent 45 dollars and the interface. and not long after there was a package in my mailbox.
the interface works better than ever.