Straight Neck?

Need to know how to setup your guitar? How do you lower your action? How do you get rid of the Milli Vanilli stickers? Look here first.
Post Reply
slash75
newbie
Posts: 1
Joined: June 7th, 2018, 3:06 am

Straight Neck?

Post by slash75 » June 7th, 2018, 4:13 am

I have a Les Paul Studio that has been sitting for a few years. Recently getting back into it.
It doesn't seem to be playing as well as it used to and I would like to straighten the neck to see if that helps.
It looks pretty close to me but I am no expert. Can anyone tell me from the photo below if this needs to be straightened or not? I have a set of light gauge strings on it currently (9-42).

https://1drv.ms/u/s!Ak6Z9f6YtvHXkz2K9a4PvlENApyN

User avatar
Musicus
newbie
Posts: 32
Joined: November 22nd, 2017, 10:52 am
Location: Nashville TN

Re: Straight Neck?

Post by Musicus » June 9th, 2018, 11:00 am

No, there's no way to tell from the photo, sorry. The general non-technical way to find out is to lower the action until you get string buzzes at any of the frets, and if the action is too high it MIGHT be fixed with truss rod adjustments, but don't do it yourself if you don't really know how. Take it to a shop.
"Well, I hope the neighbors like THIS song!"

matthewwensor21
newbie
Posts: 9
Joined: June 13th, 2018, 9:09 am
Location: Northampton, UK
Contact:

Re: Straight Neck?

Post by matthewwensor21 » July 27th, 2018, 4:27 am

My 2002 LP has a slightly twisted neck, strangely though it has no effect on the playability or tuning (yet) so Im going with the 'If it aint broke, don't fix it' analogy.
Mattie, UK based session guitarist and teacher at https://mgrmusic.com/teacher-database/

unleashedfury
newbie
Posts: 18
Joined: September 14th, 2017, 3:25 pm

Re: Straight Neck?

Post by unleashedfury » July 30th, 2018, 6:31 pm

The way I was taught to sight a neck is to lay the body of the guitar on a flat surface like a work bench and lift the neck to a 45 degree angle, look at the neck at the edges directly down the fretboard. it takes some practice and looking at a few different necks to see if you have any issues with twist or bowing. however it is the easiest way to check.

You said it sat for a few years, did you change strings? and how much of "its not playing as good as it used to is just rust your knocking off"

If your uncomfortable with performing adjustments to the trussrod or perfoming intonation bridge adjustments feel free to stop by your local music shop alot of guys do a complete setup for around 50 dollars.

JR88
newbie
Posts: 1
Joined: July 31st, 2018, 3:34 am

Re: Straight Neck?

Post by JR88 » July 31st, 2018, 3:47 am

The Beater Douglas/Agile 7 and that 26"ish stupid scale, literally plays better than poop Iv'e seen for wayyyy more. Cleaned up the torn up neck pocket and polished/leveled the Frets some, put a better pickup in the bridge, I need to get a real Floyd for it though. And it needs rewired a bunch poop I was trying.

I don't know got rid of and threw out a bunch of stuff over the years, and the house got robbed and broke into Lol.

Murtii
newbie
Posts: 1
Joined: October 1st, 2018, 12:23 am

Re: Straight Neck?

Post by Murtii » October 1st, 2018, 12:33 am

Ive recently bought a new indonesian jackson and it seems to have a slight elevation in its neck throughout on the high e side. Although it doesnt affect the playability or even cause a fret buzz but the nut also seems to be set in an inclined manner and you can also see the same side of fret board elevated around half a MM from pickups to nut. Please advice on it

Post Reply