To prove the nut is not at fault here, try placing a capo dead on top of the 1st fret & checking intonation there and at the 13th fret. Just tune...
Just to expand on Alan's response: nut slots that are not cut deep enough cause the problem you are describing. I'd put a capo on the 3rd fret &...
I believe that in order to post an image on this forum one needs to post the image on a hosting site or personal web page & link to it via the Img...
Fine when fretted but dead when open sounds like an issue at the nut end of the neck. Like the locking nut, if it's a Floyd Rose (string clamp or scr...
Not familiar with the ORM1 & don't have a schematic, but my bet is that it's the way Ibanez chose to wire the jack. Most long-barrel 1/4" jacks a...
I'd try to just tap the nut over from the protruding end using either a plastic head hammer or a small hammer & a piece of wood. The nut should b...
I've had very good results from using tape (duct or masking...just something very sticky) to lift unwanted artwork. That & a super fine sandpaper...