Sooooo....
I got a new Tascam 8-track recorder, and I wanted to record my Strat through my little honeytone amp. So, I plugged it in, played for a bit, etc etc etc. Went to unplug the cord from the dano amp to my Vox...the cord is stuck in the Dano Honeytone!!!! It comes out maybe 1/4inch, but no more. No matter what I do, it's stuck. I even pulled the back off, but the jack is enclosed, so I can't see what it's stuck on! It sucks, because not only do I love the amp, but that's a $50 planet waves cable!!! That's $70 worth of stuff I've got stuck...and it's my only cable!
Ok, anyone have any advice???????
Try just jiggling it up and down and then pulling, that might loosen it up. Otherwise take it to a guitar shop and have an amp tech look at it.
Guitars: Electric: Jackson DX10D, J. Reynolds Fat Strat copy
Acoustic: New York and a Jasmine.
Amps: Austin 15 watt, Fender Deluxe 112, Fender Champion 600 5w, 0ld 1970's Sears 500g.
Effects: Digitech Whammy, Big Muff Pi USA, MXR, Washburn Distortion.
Try just jiggling it up and down and then pulling, that might loosen it up.
And rotating the plug while doing the above.
How enclosed is the jack?
Can you see any part of the plug from the inside? Maybe you can push it out?
Or this could become the permanent (albeit expensive) cable for this amp :?
I wrapped a newspaper ’round my head
So I looked like I was deep
