Hi people
OK I have a Pioneer DJM600 Mixer (Manual here: http://www.service.pioneer-eur.com/peeservice/instrmanuals.nsf/0/E8E50DA7F229C2F041256AE10036ED2B/$File/DRB1319_DJM-600.pdf )
How do I hook my electo acoustic up to the mixer which is in turn hooked up to my big speakers.
I dont have a stand alone amp for the guitar
Thanks in advance!
Try plugging it into one of the mic inputs (ch4 - sub-mic on your mixer).
You will have to adjust the level lower than it would be for a mic (because the guitar's level is higher than a typical microphone)
I wrapped a newspaper ’round my head
So I looked like I was deep
It may even work to use a Line input.
The output from electroacoustic guitars internal Pre-Amp is sometimes high enough for a line level (200 mV) input.
/kalle
Tanglewood TW28STE (Shadow P7 EQ) acoustic
Yamaha RGX 320FZ electric guitar/Egnater Tweaker 15 amp.
Yamaha RBX 270 bass/Laney DB 150 amp.
http://www.soundclick.com/kalleinsweden
Try plugging it into one of the mic inputs (ch4 - sub-mic on your mixer).
You will have to adjust the level lower than it would be for a mic (because the guitar's level is higher than a typical microphone)
Hi tried this last night briefly and seems to be fine!
Just needed to turn down volume / gain on that line
Thanks a lot!