Skip to content

Forum

Notifications
Clear all

Impedence


(@130unstopablewatts)
Eminent Member
Joined: 11 years ago
Posts: 28
Topic starter  

So my lmc head quit working parts are on order. So I converted my line6 spider 3 into a head mounted a jack through the case wired speaker wire to that it actually drives my 4x12 crate Cab nicely. So I wanna add another out put to the back so how do I wire the second output to the existing one and keep my ohms at 4

Its 109 miles to chicago


Quote
(@130unstopablewatts)
Eminent Member
Joined: 11 years ago
Posts: 28
Topic starter  

Should have been more specific my cab is stereo but only have one line out from the spider I want another out put so I can run the cab in stereo instead of mono

Its 109 miles to chicago


ReplyQuote
 Cat
(@cat)
Noble Member
Joined: 14 years ago
Posts: 1225
 

Huh? Whuh?

Cat

"Feel what you play...play what you feel!"


ReplyQuote
(@130unstopablewatts)
Eminent Member
Joined: 11 years ago
Posts: 28
Topic starter  

OK line6 spider 3 30into watt combo I removed the speaker and cut the cabinet down so its just a head now for a half stack. I used the primal speaker wires soldered to a 1/4 inch jack and mounted it to the back so I could plug the cab into the head. I want to add another output. But I noticed on the circut board where the plug is for the speaker wire that plug is a four pin with only two pins used is the second set another speaker out not used from the factory since it was a single speaker amp.

Its 109 miles to chicago


ReplyQuote