Notifications
Clear all
Topic starter
13/11/2007 12:56 pm
Hello,
This is my first time on this forum and i was wondering if you guys could help me out.
I have a JEM and it is one of the older models. It uses a fly bridge, and i just switched from a small gauge (9 on the high e) to (11 on the high e) but now i cant get my bridge to balance! ive done everything, even by stretching the springs to the max on the bottom.
Any tips on this?
13/11/2007 7:57 pm
11s should be handled by the standard spring set given some adjustment; but maybe you have weaker springs (low tension) or too few springs (someone removed one, maybe?). Check into adding springs or swapping for springs of higher tension.
-=tension & release=-
