Notifications
Clear all
Topic starter
14/03/2009 2:41 pm
I have a Guild which has the trim/edging coming off around the lower bout. Would you use Stew-mac #16 solvent cement for acrylic?.
What do you use? What should I use?
14/03/2009 10:48 pm
Have you tried a torch yet?
"A cheerful heart is good medicine."
Topic starter
14/03/2009 11:09 pm
Not yet Rico. The Guild rings like a bell.
I should of said, the binding is coming off....wut do I use....
15/03/2009 12:25 am
"A cheerful heart is good medicine."
Topic starter
15/03/2009 2:25 am
So it's as simple as wood glue...thanks!!
15/03/2009 5:37 am
Luthiers commonly use cyanoacrylate (Superglue) for attaching and re-attaching binding ... but it does have the same finish eating properties as a solvent cement. the upside is both solvent and cyanoacrylate adhesives will bind plastic better than the much-easier-to-use/benign wood glue
-=tension & release=-
